服务电话：13823376616 企业邮箱：firstname.lastname@example.org 地址：深圳市宝安区新桥街道中心路万丰98工业城港科厂301
摘要 : 虽然使用自动焊锡机能节省人力成本，提高焊接效率，然而作为自动化设备来说平时一定要做好保养，才能延长机器的使用寿命。
Although the use of automatic soldering machine to save labor costs, improve welding efficiency, but as an automation equipment in peacetime must do a good job of maintenance, in order to extend the life of the machine。 If this is not done well, it may lead to various problems in the equipment。 For example, the automatic soldering machine iron head, the use of automatic soldering machine after the need to do a good maintenance of iron head, this is also the most common problem, good maintenance can extend the service life of automatic soldering machine, if not well maintained in the use of the process may be a variety of problems, today to share with you The daily maintenance work of soldering head of automatic soldering machine:
Everyone knows that the iron head is the heaviest structural component of the automatic soldering machine, and it is also an important part that affects the direct service life of the automatic soldering machine. If you do not do a good job of maintenance, then the trouble to you is not small, in order to not affect the production efficiency, do a good job of daily maintenance of iron head is inseparable from a very important link, maintenance work will not take up too much time, as long as before and after welding remember the following steps:
1. Choosing the right and proper temperature, the excessive temperature will weaken the function of the iron head, accelerate its oxidation, and shorten its service life. It is recommended that the temperature should not be too high at the first heating (about 260 degrees). Tin is coated on the iron head to remove the oxide coated on it. In the case of working, try to use a lower temperature, lower temperature can also be fully welded, and can be separately protected for temperature sensitive components. It is generally recommended to use a temperature of 350~380 degrees. 1.5mm less solder joints 350~360 degrees, 2.5mm larger solder joints 370~380 degrees.
2。 Automatic solder machine wipes the iron head with sponge before welding。 If the tin plating part of the iron head contains black oxide, a new tin layer can be plated, and then wipe the iron head with a wet clean sponge。 This is repeated until the oxide is completely removed, then a new tin coating is applied, and the iron head is cleaned regularly。
3。 When not using the automatic soldering machine, remember to turn off the power supply, wipe the soldering iron head clean on the clean sponge, and then a new layer of tin, or wipe the iron head clean on the clean sponge before reusing, and then a new layer of tin, not adding any compounds on the tin surface。
4. When the iron head is first used, it is necessary to adjust the temperature of the iron head to 220 degrees, so that the tin on the iron head can be eaten sufficiently, preferably soaked in the tin pile for 5 minutes, then wiped clean on the clean sponge, and the iron temperature is again adjusted to 300 degrees, repeat the above procedure, and finally adjust the iron temperature to the required use temperature. For use. The purpose is to form a comprehensive protective film on the tin layer of the soldering iron head to prevent it from being oxidized at high temperature, resulting in the failure of heat transfer.
Through the above four points I believe we must pay attention to the use of automatic soldering machine, otherwise it will affect the production efficiency, an enterprise if the production efficiency is affected, then it will lead to the production cost is too high due date can not meet the standard, this is the most important problem for enterprises. In order to make the automatic soldering machine run normally, maintenance is essential.